Comparison ledger
Advantest T5375 High-Speed Flash Memory, KLA 1007, side by side. Every value shown is drawn from the cited encyclopedia entries.
| Attribute | T5375 High-Speed Flash MemoryAdvantest | 1007KLA |
|---|---|---|
| OEM | Advantest | KLA |
| Category | Test & Probe | Test & Probe |
| Wafer size | — | — |
| Process node | — | — |
| Introduced | — | — |
| Production run | 2001– | — |
| Lifecycle | — | — |
| Lifecycle milestones | — | — |
| Control system | — | — |
| Generation | — | — |
| Family | Advantest T5375 High-Speed Flash Memory | KLA 1007 |
| Specifications | ||
| Target Devices | DRAM, SDRAM, DDR SDRAM, Direct Rambus DRAM, NOR Flash, NAND Flash, EPROM, EEPROM, Mask ROM etc.[1] | — |
| Testing Speed | Maximum of either 143 MHz or 286MHz DDR[1] | — |
| Overall Timing Accuracy | ±0.4ns[1] | — |
| Parallel Testing Capacity | Maximum of 128 DUTs (x18) when using two test-heads[1] | — |
| Manufacturer | Shinwa Controls[1] | KLA[2] |
| Model | CH7-H1-D1[1] | 1007[2] |
| Chiller Supply Voltage | 200 VAC[1] | — |
| Phase / Wire | 3 phase, 3 wire plus Ground[1] | — |
| Frequency | 50 / 60 Hz[1] | — |
| Full load current | 16 A[1] | — |
| s/n | 0309352[1] | — |
| Amps rating of largest motor | 10.6 A[1] | — |
| Electrical diagram number | HHD-W0076-03,0078-01[1] | — |
| Manufactured date | March 2009[1] | — |
| SIZE OF FMRA BOARD [0 | 0G,1:1.44G,2:2.88G] ..........> 1[1] | — |
| TYPE OF CFM [1 | TYPE-1,2:TYPE-2] .............> 1[1] | — |
| SIZE OF PM BOARD [1 | 1G,2:2G,3:4G,4:9G] ...........> 1[1] | — |
| ** START AT 2020/04/29 16 | 14:57 **[1] | — |
| ** TEST MODE | PASS PRINT **[1] | — |
| ** SPEC | 100.0% **[1] | — |
| Overall timing accuracy | ±0.4 ns[1] | — |
| Target devices | DRAM, SDRAM, DDR SDRAM, Direct Rambus DRAM, NOR Flash, NAND Flash, EPROM, EEPROM, Mask ROM[1] | — |
| Wafer size | 300mm[1] | 150 mm[2] |
| Pin configuration | 512 DR + 320 I/O (Quarter configuration)[1] | — |
| Chiller manufacturer | Shinwa Controls[1] | — |
| Chiller model | CH7-H1-D1[1] | — |
| Chiller phase/wire | 3 phase, 3 wire plus Ground[1] | — |
| Chiller frequency | 50 / 60 Hz[1] | — |
| Chiller full load current | 16 A[1] | — |
| Description | — | Wafer Prober[2] |
| Convertible to 8 inch wafer size | — | Yes[2] |
| Vintage | — | 01.06.1995[2] |
| Make | — | KLA[3] |
| Equipment type | — | Prober[3] |
Plan your fab
Building a Test & Probe process? Get a complete equipment list.
Open the fab equipment planner →